BCMZH - BUTEN GOLD SEAL LATEX HOUSE & TRIM PAINT
- MSDS: BCMZH
- Manufacturer: CALIFORNIA PRODUCTS CORP
- Product Name: BUTEN GOLD SEAL LATEX HOUSE & TRIM PAINT
- National Stock Number: 8010-00N006535
Product Identification
Product ID:BUTEN GOLD SEAL LATEX HOUSE & TRIM PAINT
MSDS Date:01/01/1985
FSC:8010
NIIN:00N006535
MSDS Number: BCMZH
Responsible Party
Emergency Phone: 617-547-5300
Cage: 08750
Contractor
Telephone: 617-547-5300 EXT 208
Cage: 08750
Ingredients
AMMONIA (SARA III)
CAS: 7664-41-7
RTECS: BO0875000
Fraction By Weight: 0.3%
OSHA PEL 50 PPM
ACGIH TLV: 25 PPM/35 STEL; 9293
EPA Report Quantity: 100 LBS
DOT Report Quantity: 100 LBS
PHENYLMERCURIC ACETATE (SARA III)
CAS: 62-38-4
RTECS: OV6475000
Fraction By Weight: 0.1%
OSHA PEL 0.1 MG HG/M3;CEIL;S
ACGIH TLV: 0.01 MG HG/M3; 9192
EPA Report Quantity: 100 LBS
DOT Report Quantity: 100 LBS
Hazards
Effects of Overexposure:EYE IRRIT. PRLNG/RPTD CONT POSS SKIN IRRIT.
VAPORS/SPRAY MIST IN POOR VENT AREA (SEE OTHER PRECAUT.)
First Aid
First Aid:EYES: FLUSH W/PLENTY OF H*2O FOR @ LEAST 15 MIN & CALL
PHYSICIAN. SKIN: WASH THROUGHLY W/SOAP & H*2O. RMV & WASH CLTHG
BEFORE REUSE. INGEST: IF CONSCIOUS GIVE 2 GLASSES OF H*2O. CALL
PHYSICIAN.
Fire Fighting
Extinguishing Media:NON-COMBUSTIBLE
Fire Fighting Procedures:WEAR MSHA/NIOSH APPRVD,PRESSURE DEMAND, SCBA.
Unusual Fire/Explosion Hazard:ACRYLIC EMULSION WILL NOT BURN. MAY
SPATTER IF TEMP EXCEEDS BOILING PT. DRIED POLYMER FILM CAN BURN.
Accidental Release
Spill Release Procedures:KEEP PEOPLE AWAY. DIKE & CONTAIN SPILL W/INERT
MATERIAL (SAND, EARTH, ETC) & TRANSFER LIQ TO CNTNR FOR
RECOVERY/DISPOSAL. KEEP SPILL OUT OF SEWER & OPEN BODIES OF H*2O.
FLOORS MAY BE SLIPPERY, CARE SH OULD BE EXERCISED TO AVOID FALLS.
Handling
Handling and Storage Precautions:MAX STORAGE TEMP 140F, MIN 34F.
PRECAUTIONARY LABELING "KEEP FROM FREEZING." SPRAY FROM COATING
MUST NOT BE INHALED, RESPIRATORS SHOULD BE PROVIDED.
Other Precautions:EFFECTS OF OVEREXPOSURE: IRRIT TO EYES, THROAT &
MUCOUS MEMB OF RESP TRACT & CAUSING HEADACHES & NAUSEA. AFTER HR
EMERGENCY NO: 617-887-5926
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPRVD RESP PROT WHERE VAPOR CONC ARE
MET.
Ventilation:MECHANICAL LOCAL EXHAUST AT PT OF CONTAMINANT RELEASE.
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY GLASSES
Other Protective Equipment:EYEWASH FACILITY, EMERGENCY SHOWER
Supplemental Safety and Health
VAP PRESS: @ 69F 17. VAP DENSITY: HEAVIER THAN AIR. SPECIFIC GRAVITY:
VARIES W/COLOR 1.1-1.3. % VOLATILE BY VOL: VARIES COLOR TO COLOR
67. FREEZING PT: 32F (H*2O).
Chemical Properties
Boiling Pt:B.P. Text:212F
Evaporation Rate & Reference:SLOWER (BUTYL AC)
Solubility in Water:DILUTABLE
Appearance and Odor:VISCOUS LIQUID, SLIGHT AMMONIACAL ODOR, PH 9-10.
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS (NITRIC ACID, PERMANGANATES), ETC.
Disposal
Waste Disposal Methods:THE COATING & ANY CONTAM DIKING MATERIAL SHOULD
BE ALLOWED TO AIR DRY. COLLECT INTO SEALED DRUMS & LABEL PROPERLY
W/WASTE DESIGNATION. DISPOSE IAW CURRENT LOCAL, STATE & FEDERAL
REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.